(207) 797-0979

PV install, Falmouth Fall 2011

Ground Mounted photovoltaic array.  36 Canadian Solar modules with Enphase micro inverters  

Goal, offset current electric bill with an expandable system that can later provide electricity for space heating. may 2015 enlighten solar output report

The owners of the array have an unusually high household electric bill.  They have already made a number of energy improvements in the home.  They also want to move to electric heat, via some type of heat pump, which will increase the load further.  The roof space was not large enough to meet the final expected demand so they made a decision to ground mount the array.   This 36 module system was designed to offset most of their load.  If additional modules were needed to cover the electricity needed by the heat pump then the roof would be utilized.  

The homeowner monitors his system performance.  Enphase micro inverters make this really easy with a wonderful web site that provides both a visual representation of the array as well as reports, graphs, exports, and a monthly summary email.   To make it easier to compare to his CMP bill the homeowner had CMP reset his billing cycle to match Enphase's monthly time module.  In 2013 this system produced 11,344  kilowatt hours of electricity or about $1,703.  Of course our electric rates are going up in March 2014 so savings will be greater every year.   As of January 2014 this system had produced 110% of expected output.  

Ground mount arrays have many advantages.  They can be oriented perfectly south and at the idea angle to optimize annual output. They are perfect if you have a small or shaded roof.  This install uses Enphase micro inverters that are mounted on the back of each module.   Ground mounting makes they very easy to access should they ever need maintenance.   We generally don't recommend cleaning modules but in Spring when we get the heavy yellow pollen it can impact PV performance.   If we don't get rain it is easy to wash ground mount arrays.  While this array is fixed there are pole mounts that allow the modules to track the sun.  These can increase production by 30% or more.  They add cost and maintenance so many times it is less expensive to just add more modules.  

At this install we poured concrete footing but newer racks are have heavy ballasts and do not require ground penetration, thus saving labor.  There also screw and other type anchors that speed up install time and save you money.  We then built the frame from 3" galvanized pipe.  Iron Ridge solar rails were then installed and then the inverters and modules.  

 

   carner frame in progress with Steve F           carner 001 frame half done cropped low res      carner 006 full array upon completion

 

   

 

 

Ready to get started?

Contact us today with your questions or to set up your free consultation.

Contact Us

 

PV Cost and Net Metering

Podcast explains Net Metering &  how much cheaper PV electric is vs. the utlity

Solaris

600 Riverside St.

Portland ME 04103

(207) 797-0979

Copyright 2017 Solaris Thermal. All rights reserved.

Website designed and maintained by